Hyundai Genesis (DH): Lubrication System / Oil Pump Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Mechanical System / Lubrication System / Oil Pump Repair procedures

Removal and Installation
1.
Remove the lower oil pan.
(Refer to Lubrication System - "Oil pan")
2.
Remove the upper oil pan.
3.
Remove the bolt (A) and then separate the chain with sprocket from the oil pump.
Tightening torque :
19.6 ~ 24.5 N.m (2.0 ~ 2.5 kgf.m, 14.5 ~ 18.1 lb-ft)

4.
Remove the oil of proportional control solenoid connector (A).

5.
Remove the oil pump bracket bolt (A).

6.
After loosening the oil pump mounting bolt, remove the oil pump (A) and upper oil pan together.
Tightening torque :
20.6 ~ 22.6 N.m (2.1 ~ 2.3 kgf.m, 15.2 ~ 16.6 lb-ft)

7.
To install, reverse the removal procedure.

    Components 1. Oil pump (2WD)2. Oil pump (AWD)3. Oil pump sprocket

    Components 1. Engine oil level gauge2. Engine oil level gauge rod

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Description and Operation

    Description BSD is a system that measures the speed of and distance from the following vehicles by using two magnetic wave radar sensors attached to the rear bumper, and detects any vehicle within the blind spot zone and gives off alarm (visual and auditory).

    Hyundai Genesis (DH) 2013-2016 Service Manual: Blower Motor Repair procedures

    Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, replace it with a genuine blower motor check for proper operation. 3. Replace the blower motor if it is proved that there is a problem with it.

    Categories

     
    Copyright В© 2025 www.hgenesisdh.com - 0.0254