Hyundai Genesis (DH): Lubrication System / Oil Filter Body Repair procedures

Removal and Installation
Oil filter body
1.
Disconnect the battery "-" terminal from the trunk room.
2.
Remove the engine under cover.
(Refer to Engine And Transaxle Assembly - "Engine Room Under Cover")
3.
Remove the engine oil filter body (A).

Tightening torque :
20.6 ~ 22.6 N.m (2.1 ~ 2.3 kgf.m, 15.2 ~ 16.1 lb-ft)

   

    Components 1. Oil filter cap2. O-ring3. Oil filter element4. Oil filter body5. Oil seal

    Components 1. 2WD Lower oil pan2. AWD Lower oil pan3. 2WD Upper oil pan4. AWD Upper oil pan5. Cylinder block

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: High Mounted Stop Lamp Repair procedures

    Removal High Mounted Stop Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim assembly. (Refer to Body - "Roof Trim") 3. Remove the high mounted stop lamp assembly (A) after loosening the mounting screws. Installation 1.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Defogging Sensor Description and Operation

    Description The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives signal from the sensor and restrains moisture and eliminate defog by controlling the intake actuator, A/C, auto defogging actuator,

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0218