| Inspection |
| 1. |
Disconnect the negative battery terminal(-). |
| 2. |
Remove the overhead console. |
| 3. |
Remove the screws(A) and connector, Remove the hands-free mic(B).
|
| 4. |
Check the continuity of mic between terminals
|
Removal 1. Disconnect the battery(-)terminals. 2. Remove the floor console assembly. (Refer to Body - "Floor Console Assembly") 3. Remove the multimedia jack tray (A) after loosening the screws from the floor console (B).
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting nuts. Take care not to separate the bracket from rear bumper when removing the BSD sensor.
Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with the L wrench (A). Tightening torque : 9.81 ~ 14.71 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft) 3. Remove the receiver-drier (A) from condenser using a long nose plier.