Hyundai Genesis: IMS(Integrated Memory System) / Memory power seat switch Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the driver's door trim. (Refer to Body - "Front Door Trim")

3.	Remove the memory power seat switch connector (A).

4.	Loosen the mounting screws and remove the memory power seat switch (A).

Installation

1.	Install the memory power seat control switch (IMA).

2.	Install the door trim.

3.	Connect the negative (-) battery terminal.

inspection

1.	Remove the memory power seat connector

2.	When each switch is pressed, check the electric current between memory power seat switch connector and grounding, and if the electricity does not match the specification, replace the switch.

Memory power seat switch Components and Components Location

Components ...

Tilt & Telescope Control (SCM) Description and Operation

Description The Tilt & Telescope operation function in SCM contains of the following function. 1. Manual control with direction switches (Tilt Up/Down, Telescope Forward/Backward). 2. Pla ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Transmission Oil Temperature Sensor Repair procedures

Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the resistance is within the specification. ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Rear Differential Carrier Components and Components Location

Component 1. Rear differential carrier assembly Component [With Lambda Engine] 1. Pinion lock nut 2. Companion flange 3. Pinion oil seal 4. Pinion front bearing 5. Differential carrier 6. Side oil seal 7. Drain plug 8. Pinion bearing spacer 9. Pinion rear bearing 10. Inner bearing ...