Hyundai Genesis (DH): Brake System / Master Cylinder Components and Components Location
| Components |
| 1. Reservoir cap 2. Reservoir | 3. Grommet 4. Master cylinder |
Brake Booster Operating Test For simply checking the brake booster operation, perform the following tests. 1. Run the engine for one or two minutes, and then stop it.
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the ECM connector (A) and TCM connector (B). IDB (C) and then remove the noise barrier (D).
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Rheostat Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the lower crash pad switch assembly (A) after disengaging the mounting clip. 4. Remove the rheostat switch connector (A).
Hyundai Genesis (DH) 2013-2016 Service Manual: Condenser Repair procedures
Inspection 1. Check the condenser fins for clogging and damage. If they are clogged, clean them with water, and blow them with compressed air. If they are bent, gently bend them using a screwdriver or pliers. 2. Check the condenser connections for leakage, and repair or replace it, if required.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Heating, Ventilation and Air Conditioning
- Body (Interior and Exterior)
- Emission Control System
- New on site
- Most important about car
