Hyundai Genesis (DH): Automatic Transmission Control System / Line Pressure Control Solenoid Valve Repair procedures
Hyundai Genesis (DH) 2013-2016 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Line Pressure Control Solenoid Valve Repair procedures
| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Disconnect the E Module connector. |
| 3. |
Measure resistance between solenoid valve terminals. |
| 4. |
Check that the resistance is within the specification. |
Circuit Diagram
Description Damper Clutch control solenoid valve is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the Damper Clutch.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting nuts. Take care not to separate the bracket from rear bumper when removing the BSD sensor.
Hyundai Genesis (DH) 2013-2016 Service Manual: Description and Operation
D
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Engine Control / Fuel System
- Body (Interior and Exterior)
- Restraint
- New on site
- Most important about car
Copyright В© 2025 www.hgenesisdh.com - 0.0215