Hyundai Genesis (DH): Airbag Module / Knee Airbag (KAB) Module Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Restraint / Airbag Module / Knee Airbag (KAB) Module Repair procedures

Removal
1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Remove the Mounting nuts (A).

4.
Remove the srcrews(A)and Connector (B).

5.
Push the clip(A), you are removing the knee air bag module.

Installation
1.
Disconnect the battery negative cable and wait for at least three minutes.
2.
install the Knee airbag .
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
3.
Install the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
4.
Reconnect the battery negative cable.
5.
After installing the knee airbag, confirm proper system operation.
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off.

    Components

    Airbag Disposal Special tool required Deployment tool 0957A-34100A Before scrapping any airbags or side airbags (including those in a whole vehicle to be scrapped), the airbags or side airbags must be deployed.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Description and Operation

    System Overview RPAS (Rear Parking Assist System) is an electronic driving aid that warns the driver to be cautious while parking or driving at low speed. The sensor uses ultrasonic waves to detect objects within proximity of the vehicle. RPAS consists of four RPS sensors which are detecting the obstacles and transmit the result separat

    Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Indicator Components and Components Location

    C

    Categories

     
    Copyright В© 2025 www.hgenesisdh.com - 0.0259