Hyundai Genesis (DH): Automatic Transmission Control System / Input Speed Sensor Repair procedures
Hyundai Genesis (DH) 2013-2016 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Input Speed Sensor Repair procedures
| Inspection |
| 1. |
Check signal waveform of Input speed sensor using the GDS.
|
Circuit Diagram
Description Middle speed sensor is a vital unit that measures the direction of rotation of the input shaft inside the transmission and delivers the readings to the TCM.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: High Mounted Stop Lamp Repair procedures
Removal High Mounted Stop Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim assembly. (Refer to Body - "Roof Trim") 3. Remove the high mounted stop lamp assembly (A) after loosening the mounting screws. Installation 1.
Hyundai Genesis (DH) 2013-2016 Service Manual: Compressor Repair procedures
Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative (-) battery terminal. 3. Remove the engine room cover.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Body (Interior and Exterior)
- General Information
- Brake System
- New on site
- Most important about car
Copyright В© 2026 www.hgenesisdh.com - 0.0292