| Specification |
| Ignition System |
| Item | Specification |
| Primary Coil Resistance (?) | 0.62 |
Troubleshooting Ignition System SymptomSuspect AreaRemedyEngine will not start or is hard to start (Cranks OK)Ignition lock switchInspect ignition lock switch, or replace as requiredIgnition coilInspect ignition coil, or replace as requiredSpark plugsInspect spark plugs, or replace as requiredIgnition wiring disconnected or brokenRepair wiring, or replace as requiredRough idle or stallsIgnition wiringRepair wiring, or replace as requiredIgnition coilInspect ignition coil, or replace as requiredEngine hesitates/poor accelerationSpark plugs and spark plug cablesInspect spark plugs / cable, or replace as requiredIgnition wiringRepair wiring, or replace as requiredPoor mileageSpark plugs and spark plug cablesInspect spark plugs / cable, or replace as required Charging System SymptomSuspect AreaRemedyCharging warning indicator does not light with ignition switch "ON" and engine off.
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Remove the blind spot detection (BSD) switch (A) after disengaging the mounting clip. Installation 1. Install the crash pad side switch assembly after connecting the connector.
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the warm (Driver's side) or cool (Passenger's side) position when connecting 12V to terminal 3 and grounding terminal 4.