Hyundai Genesis (DH): Steering wheel / Repair procedures

Removal
1.
Disconnect the battery negative cable from the battery and then wait for at least 30 seconds.
2.
Turn the steering wheel so that the front wheels are placed in the straight ahead position.
3.
Remove the airbag module.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")
4.
Disconnect the connector & lock bolt (A) and then remove the steering wheel by using special service tool (09561-11001).

   
Tighten the lock bolt appropriately and install the SST (09561-1101) in order to separate the steering wheel easily.
   
Do not use a hammer to remove the steering wheel, it may damage the steering column.
5.
Install in the reverse order of removal.
   
When installing, do not reuse the steering lock bolt.
Disassembly
1.
Remove the screw and separate the lower cover.

2.
Disconnect the steering wheel remote switch connector (A).

3.
Remove the remote control switch (A) & (B).

4.
Install in the reverse order of removal.

    Components 1. Airbag module2. Remote control switch3. Steering wheel4. Wiring5. Lower cover

    Components 1. Heated steering wheel switch

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Photo Sensor Repair procedures

    Inspection 1. Turn the ignition switch ON. 2. Connect the GDS. 3. Emit intensive light toward the photo sensor using a lamp, and check the output voltage change. 4. The voltage will rise with higher intensive light and fall with lower intensive light.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Temperature Control Actuator Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the warm (Driver's side) or cool (Passenger's side) position when connecting 12V to terminal 3 and grounding terminal 4.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0232