Hyundai Genesis (DH): Engine Control System / Purge Control Solenoid Valve (PCSV) Specifications

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Control / Fuel System / Engine Control System / Purge Control Solenoid Valve (PCSV) Specifications

Specification
Item
Specification
Coil Resistance (?)
22.0 ~ 26.0 [20

    Description Purge Control Solenoid Valve (PCSV) is installed on the surge tank and controls the passage between the canister and the intake manifold.

    Circuit Diagram

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Unit Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting nuts.     Take care not to separate the bracket from rear bumper when removing the BSD sensor.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Blower Unit Components and Components Location

    Component Location Components 1. Seal2. Intake Duct Case3. Intake Door4. Intake Actuator5. Intake Duct Case (A)6. Climate Control Air Filter7. Climate Control Air Filter Cover8. Cluster Ionizer9. Blower Upper Case10. Blower Lower Case11. Power Mosfet12.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0361