| Removal |
| 1. |
Disconnect the battery negative cable and wait for at least three minutes before beginning work. |
| 2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel") |
| 3. |
Remove the Mounting nuts (A).
|
| 4. |
Remove the srcrews(A)and Connector (B).
|
| 5. |
Push the clip(A), you are removing the knee air bag module.
|
| Installation |
| 1. |
Disconnect the battery negative cable and wait for at least three minutes. |
| 2. |
install the Knee airbag .
|
| 3. |
Install the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel") |
| 4. |
Reconnect the battery negative cable. |
| 5. |
After installing the knee airbag, confirm proper system operation.
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off. |
Airbag Disposal Special tool required Deployment tool 0957A-34100A Before scrapping any airbags or side airbags (including those in a whole vehicle to be scrapped), the airbags or side airbags must be deployed.
Inspection with GDS Initialization and diagnosis sequence by using GDS equipment. The following is the summarized A/S procedure. NoProcedure1Park the vehicle on level ground2Tire check3IGN1 ON4Head lamp Low Beam ON5Connection with diagnostic tool6Initial command by diagnostic tool7Clear DTC Code8IGN1 OFF > ON9Re- Connection with diagnostic t
Oil Specification 1. The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. 2. Compressor (PAG) oil varies according to compressor model. Be sure to use oil specified for the compressor model.