Hyundai Genesis (DH): General Information / Important Safety Notice
General Information
Proper service methods and repair procedures are essential
for safe, reliable operation of all motor vehicles as well as personal
safety of the operator. The service procedures and descriptions in this
shop manual provide general directions for service and repair.
There are various procedures, techniques, tools and pars for service as well as the skill of technicians.
Therefore, it is impossible for this manual to provide advice or caution for each case.
Accordingly, if you use a replacement part, service
procedure, or tool which are not recommended by the vehicle
manufacturer, make sure that neither the personal safety nor the safe
operation of the vehicle is jeopardized.
|
Reminds you to be especially careful in those areas where carelessness will cause death or serious injury. |
|
Reminds you to be especially careful in those areas where carelessness may cause death or serious injury. |
|
Reminds you to be especially careful in those areas where carelessness may cause personal injury. |
|
Gives you information that will prevent you from making errors that could damage the vehicle. |
|
Gives you additional information that will help you complete a particular procedure. |
The following list contains some general WARNINGS that you should follow while working on a vehicle.
General Information
Identification Number
Identification Number Description
Vehicle Identification Number
1.
World Manufacturer Identifier (WMI)
- KMF : Commercial vehicle (Van)
- KMH : Passenger vehicle or MPV(Multipurpose Passenger Vehicle)/SUV(Sports Utility Vehicle)/RV(Recreational Vehicle)
- KMJ : Van
- KM8 : MPV/SUV/RV (For U.
Other information:
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad")
3.
Remove the blind spot detection (BSD) switch (A) after disengaging the mounting clip.
Installation
1.
Install the crash pad side switch assembly after connecting the connector.
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the intake actuator connector.
3.
Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 and grounding terminal 4.
Verify that the intake actuator operates to the recirculation position when connected in reverse.
