Hyundai Genesis (DH): Fuel Delivery System / Fuel Pressure Regulator Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Fuel Pressure Regulator Repair procedures

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System -"Release Residual Pressure in Fuel Line")
   

    Removal 1. Release the residual pressure in fuel line. (Refer to Fuel Delivery System -"Release Residual Pressure in Fuel Line")    

    Description The fuel pump control module (FPCM) is installed on the right side of the trunk compartment. It controls the BLDC (Brushless DC) motor mounted inside the variable low pressure fuel pump.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Switch Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Remove the blind spot detection (BSD) switch (A) after disengaging the mounting clip. Installation 1. Install the crash pad side switch assembly after connecting the connector.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Compressor Description and Operation

    Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low-pressure and low-temperature refrigerant gas into high-pressure and high-temperature refrigerant gas.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0238