Hyundai Genesis (DH): Front Door / Front Door Window Glass Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Body (Interior and Exterior) / Front Door / Front Door Window Glass Repair procedures

Replacement
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
After loosening the mounting screws, remove the front door belt outside weatherstrip (A).

3.
Separating the mounting plug hole (A) from the front door module.
Lower the glass by operating the power window switch until the glass mounting bolt is exposed in the plug hole
4.
After unscrewing the mounting bolt (B) as loosely as possible and completely loosening the bolt (C), tilt the front door window glass (D) to pull out it upwards.
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

   

    Component Location 1. Front door window glass

    Component Location 1. Front door module

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: A/C Pressure Transducer Description and Operation

    Description The A/C Pressure Transducer (APT) converts the pressure value of high-pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the cooling fan by operating it at high speed or low speed.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Cluster Ionizer Repair procedures

    Inspection 1. Press the MODE switch more than 4 times within 2 seconds while pressing the OFF switch. DisplayFail description00Normal51Cluster ion generator fault * For diagnostic procedure, refer to DTC guide. Replacement 1. Disconnect the negative (-) battery terminal.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0205