Hyundai Genesis (DH): Ignition System / Description and Operation

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Electrical System / Ignition System / Description and Operation

Description
Ignition timing is controlled by the electronic control ignition timing system.
The standard reference ignition timing data for the engine operating conditions are pre-programmed in the memory of the ECM (Engine Control Module).
The engine operating conditions (speed, load, warm-up condition, etc.) are detected by the various sensors. Based on these sensor signals and the ignition timing data, signals to interrupt the primary current are sent to the ECM.
The ignition coil is activated, and timing is controlled.

    On-vehicle Inspection Inspect ignition coil assembly and Perform spark test 1. Check for DTCs.    

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Compressor oil Repair procedures

    Oil Specification 1. The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. 2. Compressor (PAG) oil varies according to compressor model. Be sure to use oil specified for the compressor model.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Heater & A/C Control Unit Repair procedures

    Self Diagnosis 1. Self-diagnosis process 2. How to read self-diagnostic code After the display panel blinks three times every 0.5 second, the corresponding fault code blinks on the setup temperature display panel every 0.5 second and will show two figures.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0284