Hyundai Genesis (DH): Automatic Transmission Control System / 8LR Brake Control Solenoid Valve Specifications

Hyundai Genesis (DH) 2013-2016 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / 8LR Brake Control Solenoid Valve Specifications

Specifications
Direct control VFS[8LR/B]
? Control Type : Normal low type
Control Pressure kpa (kgf/cm?, psi)
0~2108.42
(0~21.5~305.80)
Current value(mA)
0~1100
 Internal resistance(?)
5.0~5.6

    Description 8LR Brake control solenoid valve is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the 8LR Brake.

    Circuit Diagram

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Rheostat Repair procedures

    Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the lower crash pad switch assembly (A) after disengaging the mounting clip. 4. Remove the rheostat switch connector (A).

    Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Light Sensor Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the photo & auto light sensor. (Refer to Windshield Wiper/Washer - "Rain Sensor") Installation 1. Install the auto light sensor. 2. Connect the negative (-) battery terminal.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0224