Hyundai Genesis (DH): Automatic Transmission Control System / 27 Brake Control Solenoid Valve Description and Operation
Hyundai Genesis (DH) 2013-2016 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / 27 Brake Control Solenoid Valve Description and Operation
| Description |
27 Brake control solenoid valve is attached to the valve
body. This variable force solenoid valve directly controls the hydraulic
pressure inside the 27 Brake.
Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between solenoid valve terminals. 4.
Specifications Direct control VFS[27/B] ? Control type : Normal low type Control Pressure kpa (kgf/cm?, psi)0~1569.06 (0~16,0~227.57)Current value(mA)0~1100 Internal resistance(?)5.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Light Sensor Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the photo & auto light sensor. (Refer to Windshield Wiper/Washer - "Rain Sensor") Installation 1. Install the auto light sensor. 2. Connect the negative (-) battery terminal.
Hyundai Genesis (DH) 2013-2016 Service Manual: Specifications
S
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Emission Control System
- Engine Mechanical System
- Restraint
- New on site
- Most important about car
Copyright В© 2026 www.hgenesisdh.com - 0.0209