Hyundai Genesis: Fuel Delivery System / Fuel Sender Assembly Repair procedures

Removal
1.
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System -"Release Residual Pressure in Fuel Line")
   
When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may turn up. Delete the code with the GDS after completion of “Release Residual Pressure in Fuel Line” work.
2.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
3.
Remove the fuel pump.
(Refer to Fuel Delivery System - "Fuel Pump")
4.
Disconnect the fuel sender connector (A).

5.
Remove the fuel sender (A) after releasing the fixing hook.

Installation
1.
To install, reverse the removal procedure.
Fuel Pump Motor Repair procedures
Removal 1. Release the residual pressure in fuel line. (Refer to Fuel Delivery System -"Release Residual Pressure in Fuel Line")     • When removing the fuel pump relay, a ...

Fuel Pressure Regulator Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Release the residual pressure in fuel line. (Refer to Fuel Delivery System -"Release Residual Press ...

Other information:

Hyundai Genesis (DH) 2013-2016 Owners Manual: Electric power steering (EPS)


The system assists you with steering the vehicle. If the engine is turned off or if the power steering system becomes inoperative, you may still steer the vehicle, but it will require increased steering effort. Should you notice any change in the effort required to steer during normal ...

Hyundai Genesis (DH) 2013-2016 Owners Manual: Securing a child restraint seat with “Tether Anchor” system


First secure the child restraint with the LATCH lower anchors or the seat belt. If the child restraint manufacturer recommends that the top tether strap be attached, attach and tighten the top tether strap to the top tether strap anchor. Child restraint hook holders are located on t ...

© 2013-2025 www.hgenesisdh.com