Hyundai Genesis (DH): Fuel Delivery System / Fuel Pressure Sensor (FPS) Description and Operation

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Fuel Pressure Sensor (FPS) Description and Operation

Description
The fuel pressure sensor (FPS) is installed on top of the low pressure fuel pump and measures the pressure of the low pressure fuel line. Based on the current fuel pressure and the amount of fuel consumed, the fuel pump control module (FPCM) determines whether to activate the low pressure fuel pump. After activating the low pressure fuel pump, the FPS continues to communicate with the FPCM to measure the fuel pressure and control the supply of low pressure fuel.

    Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. If there is DTC on the GDS, replace the FPCM. 3. Check the output voltage of fuel pressure sensor (FPS).

    Specification Pressure(kPa)Output Voltage(V)500.36002.511004.5

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Rear Combination Lamp Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. After loosening the nuts (4EA) holding the rear combination lamp and disconnecting the connector (A), remove the outside rear combination lamp assembly. 3. Remove the bulb (A) after turning it in the counter clock-wise direction.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Intake Actuator Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 and grounding terminal 4. Verify that the intake actuator operates to the recirculation position when connected in reverse.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0355