Hyundai Genesis: Fuel Delivery System / Fuel Filter Repair procedures

Removal

1.	Release the residual pressure in fuel line. (Refer to Fuel Delivery System -"Release Residual Pressure in Fuel Line") • When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may turn up. Delete the code with the GDS after completion of “Release Residual Pressure in Fuel Line” work.

2.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

3.	Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump")

4.	Remove the fuel sender assembly. (Refer to Fuel Delivery System - "Fuel Sender Assembly")

5.	Disconnect the pump connector (A).

6.	Disconnect the suction hose (A) after releasing the fixing hook.

7.	Remove the fixing clip (B), and then disconnect the fuel feed tube quick-connector (C).

8.	Remove the reservoir-cup (B) after releasing the fixing hooks (A).

9.	Remove the dual hose (A).

10.	Disconnect the ground (B).

11.	Remove the fuel pressure regulator (D) after releasing the fixing clips (C).

12.	Disconnect the dual hose (A).

13.	Disconnect the fuel pump motor connector (B).

14.	Remove the fuel pump motor (B) after releasing the fixing hooks (A).

Installation

1.	To install, reverse the removal procedure.

Sub Fuel Sender Repair procedures

Removal 1. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line") 2. Fold the rear seat cushion. 3. Remove the fuel pump se ...

Fuel Pump Motor Components and Components Location

Components Pin NO.ItemDescription1Upper body3-phase coil power supply, fuel delivery, and sealing2Stator assemblyCreates an N pole and S pole flux to induce the rotor to turn.3rotor assemblyTorqu ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Crankshaft Damper Pulley Repair procedures

Removal and Installation 1. Remove the drive belt. (Refer to Timing System - "Drive Belt") 2. Remove the engine under cover. 3. Remove the crankshaft pulley (A). Tightening torque : 284.5 ~ 304.1 N.m (29 ~ 31 kgf.m, 209.8 ~ 224.2 lb-ft)     To fix the pulley to ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Description and Operation

Description AEB(Autonomous Emergency Braking) is a function purposed to avoid the collision or to reduce the damage against the accident which can be taken place from the late braking or insufficient braking power due to the reason of absented mind of the driver. The sequence of system con ...