Other information:
Inspection
1.
Check the condenser fins for clogging and damage. If they are
clogged, clean them with water, and blow them with compressed air. If
they are bent, gently bend them using a screwdriver or pliers.
2.
Check the condenser connections for leakage, and repair or replace it, if required.
Replacement
1.
Remove the condenser.
2.
Remove the cap (B) on the bottom of the condenser with the L wrench (A).
Tightening torque :
9.81 ~ 14.71 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)
3.
Remove the receiver-drier (A) from condenser using a long
nose plier.