Hyundai Genesis: Front Bumper / Front Bumper Cover Repair procedures

Replacement

• Put on gloves to prevent hand injuries.

• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface. • Take care not to bend or scratch the trim and panels.

1.	Remove the radiator grill upper cover. (Refer to Engine Mechanical System - "Engine and Transmission assembly")

2.	Loosen the pin-type retainers and bolts of the front bumper upper. [Lambda engine] [Tau engine]

3.	Loosen the front bumper lower pin-type retainers.

4.	After loosening the pin-type retainers and screws on the side of front bumper (A) , detach the side part of front bumper. • Slightly lift up the side of the rear bumper and pull it out in the direction of arrow. • Be careful not to damage the tabs on the side part of front bumper.

5.	Disconnect the front bumper main connector (A).

6.	Remove the front bumper cover (A). [Lambda engine] [Tau engine]

7.	Install in the reverse order of removal. • Make sure the connector is connected properly. • Replace any damaged pin-type retainers.

Front Bumper Cover Components and Components Location

Component Location 1. Front bumper cover ...

Radiator Grill Components and Components Location

Component Location 1. Radiator grill ...

Other information:

Hyundai Genesis (DH) 2013-2016 Owners Manual: ESC OFF usage

When Driving The ESC OFF mode should only be used briefly to help free the vehicle if stuck in snow or mud by temporarily stopping operation of the ESC to maintain wheel torque. To turn ESC off while driving, press the ESC OFF button while driving on a flat road surface. CAUTION To p ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Crash Pad Main Lower Assembly Components and Components Location

Component Location 1. Crash pad main lower assembly ...