| Description |
Never measure the resistance of the anchor pretensioner
directly, the current of the measuring device may cause unexpected
airbag deploy. |
Removal 1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front anchor seat belt (A).
Inspection 1. Ignition "ON". 2. Turn on the head lamp switch. 3. Check that the aim of the head lamp changes smoothly when the head lamp leveling device switch is turned on. 4. If it does not operate well, check the connector and terminals to make sure that they are connected.
Inspection 1. Press the MODE switch more than 4 times within 2 seconds while pressing the OFF switch. DisplayFail description00Normal51Cluster ion generator fault * For diagnostic procedure, refer to DTC guide. Replacement 1. Disconnect the negative (-) battery terminal.