The starting system includes the battery, starter, solenoid
switch, ignition switch, inhibitor switch (A/T), clutch pedal switch
(M/T), ignition lock switch, connection wires and the battery cable.
When the ignition key is turned to the start position, current flows and energizes the starter motor's solenoid coil.
The solenoid plunger and clutch shift lever are activated,
and the clutch pinion meshes with the ring gear, which makes the starter
motor crank.
In order to prevent damage caused by excessive rotation of
the starter armature when the engine starts, the clutch pinion gear
overruns.
Other information:
Removal
For the vehicle equipped with the immobilizer, the procedures shown below must be performed after replacing the ECM.
[In the case of installing used ECM]
1) Perform "ECM Neutral mode" procedure with GDS. (Refer to "Immobilizer" in BE group)
2) After finishing ...
Troubleshooting
Trouble symptomProbable causeRemedyHard steeringImproper front wheel alignmentRepairExcessive turning resistance of lower arm ball jointReplaceFlat tireAdjustNo power assistRepair or ReplacePoor return of steering wheel to centerImproper front wheel alignmentRepairPoor ride qual ...