Hyundai Genesis: Engine Control System / Crankshaft Position Sensor (CKPS) Repair procedures
| 1. |
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
|
|
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
| 2. |
Disconnect the crankshaft position sensor connector (A). |
| 3. |
Remove the installation bolt (B), and then vertically remove the sensor from the transaxle housing. 
|
| • |
Install the component with the specified torques. |
| • |
Note that internal damage may occur if the component drops. If the component drops, inspect it before installation. |
|
| • |
Insert the sensor in the installation hole and be careful not to damage during installation.
|
|
| 1. |
To install, reverse the removal procedure.
Crankshaft position sensor installation bolt:
6.9 ~ 9.8 N.m (0.7 ~ 1.0 kgf.m, 5.1 ~ 7.2 lb-ft)
|
|
Description
Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element.
It is related with Crankshaft Position Sensor (CKPS) and
detects the pisto ...
Other information:
Component Location
1. Front door outside handle
...
Removal
1.
Disconnect the brake fluid level switch connector, and remove the reservoir cap.
2.
Remove the brake fluid from the master cylinder reservoir with a syringe.
3.
Remove the wheel & tire.
4.
Disconnect the brake hose clip (A) and then remove the brake tube by loosening t ...
Crankshaft Position Sensor (CKPS) Schematic Diagrams
Camshaft Position Sensor (CMPS) Description and Operation