| Removal |
| 1. |
Disconnect the negative(-) battery terminal. |
| 2. |
Remove the floor console assembly.
(Refer to Body - "Floor Console Assembly") |
| 3. |
Remove the multimedia jack tray (A) after loosening the screws from the floor console (B).
|
| 4. |
Remove the multimedia jack (B) from the floor console after disengaging the fixed hooks (A).
|
| Installation |
| 1. |
Connect the multimedia jack connector. |
| 2. |
Install the multimedia jack. |
| 3. |
Install the center fascia lower tray.
|
Description The multimedia jack on the console upper cover is for customers who like to listen to external portable music players like the MP3, iPod and etc.
Inspection 1. Disconnect the negative (-)battery terminal. 2. Remove the overhead console. 3. Remove the hands-free mic(B) after loosening the screws and connector (A).
Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace any faulty tubes or hoses. Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten the bolt or nut joint to the specified torque.
Description The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives signal from the sensor and restrains moisture and eliminate defog by controlling the intake actuator, A/C, auto defogging actuator,