Hyundai Genesis: Advanced smart cruise control system / To convert to Cruise Control Mode

The driver may choose to only use the Cruise Control Mode (speed control function) by doing as follows:

1.Turn the Smart Cruise Control System on (the cruise indicator light will be on but the system will not be activated).

2.Push and hold the Vehicle-to- Vehicle Distance button for more than 2 seconds.

3.Choose between "Smart Cruise Control (SCC) Mode" and "Cruise Control (CC) Mode".

When the system is canceled using the CRUISE button or the CRUISE button is used after the engine is turned on, the SCC Mode will turn on.

WARNING

When using the Cruise Control Mode, you must manually adjust the distance to other vehicles by depressing the accelerator or brake pedal. The system does not automatically adjust the distance to vehicles in front of you.

Advanced smart cruise control system
➀ Cruise Indicator ➁ Set Speed ➂ Vehicle-to-Vehicle Distance The Smart Cruise Control System allows you to program the vehicle to maintain constant speed and distance detecting the ...

Smart Cruise Control speed
To set Smart Cruise Control speed 1.Push the CRUISE button on the steering wheel to turn the system on. The CRUISE indicator will illuminate. 2.Accelerate to the desired speed. The Smart Cr ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Rear Driveshaft (VL-VL TYPE) Components and Components Location


Component Location 1. Rear driveshaft LH2. Rear differential carrier assembly3. Rear driveshaft RH ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Stop Lamp Switch Repair procedures


Adjustment 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the lower crash pad. (Refer to Body - "Crash Pad") 3. Remove the knee airbag. (Refer to Restraint - "Air Bag Module") 4. Confirm the gap between stop lamp switch and bracket. Stop la ...

© 2013-2024 www.hgenesisdh.com