Hyundai Genesis (DH): Button Engine Start System / Start/Stop Button Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Body Electrical System / Button Engine Start System / Start/Stop Button Repair procedures

Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the driver crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Remove the start/stop button (A) from the center fascia garnish after loosening the mounting clip.

4.
Disconnect the start/stop button connector.
Installation
1.
Install the start/stop button.
2.
Install the crash pad lower panel.
3.
Connect the negative (-) battery terminal.

    Component

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Description and Operation

    Description BSD is a system that measures the speed of and distance from the following vehicles by using two magnetic wave radar sensors attached to the rear bumper, and detects any vehicle within the blind spot zone and gives off alarm (visual and auditory).

    Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Defogging Actuator Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the auto defogging connector. 3. Verify that the auto defogging actuator operates to the open position when connecting 12V to terminal 3 and grounding terminal 4. Verify that the auto defogging actuator operates to the close position when connected in reverse.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0277