Hyundai Genesis: General Information / Specifications

Specification
Item
Specification
Product name
Transfer case
Operation method
Electronic actuator control method (BLDC motor)
Torque capacity
1,100 Nm
Weight
25 kg (Oil injection state)

Tightening Torques
Item
 N.m
 Kgf.m
 lb-ft
Bolt for fixing the transfer case
29.4 ~ 41.2
3.0 ~ 4.2
21.7 ~ 30.4
Bolt for fixing the front propeller shaft
49.0 ~ 68.6
5.0 ~ 7.0
36.2 ~ 50.6
Bolt for fixing the rear propeller shaft
88.3 ~ 107.9
9.0 ~ 11.0
65.1 ~ 79.6

Lubricant
Item
Defined lubricant
Capacity
Transfer oil
Exclusive oil for transfer case
Ultra low viscosity of ATF Shell TF0870
0.620L
(0.165 U.S gal., 0.66 U.S.qt., 0.55 Imp.qt.)

General Information
...

Description and Operation
Description 1. Description A. This system is to optimize driving performance through distributing the driving force to the front and rear wheels actively depending on the road condition and ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Trunk Lid Key Holder Repair procedures


Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • Take care not to scratch the body surface. ...

Hyundai Genesis (DH) 2013-2016 Owners Manual: Dynamometer testing


An AWD vehicle must be tested on a special four wheel chassis dynamometer. An AWD vehicle should not be tested on a 2WD roll tester. If a 2WD roll tester must be used, perform the following procedure: 1.Check the tire pressures recommended for your vehicle. 2.Place the rear wheels o ...

© 2013-2024 www.hgenesisdh.com