Hyundai Genesis: General Information / Specifications

Specification

Item		Specification
Compressor	Type	7VSX18
	Oil type & Capacity	PAG 120±10cc (4.1±0.3oz.)
	Pulley type	Around rubber damper
	Displacement	180cc/rev
Condenser	Heat rejection	18,500-3% kcal/h
Expansion valve	Type	Block type
Refrigerant	Type	R-134a
	Capacity	700 ± 25g (24.7 ± 0.88oz.)

Item		Specification
Fresh and recirculation	Operating method	Actuator
Blower	Type	Sirocco pan
	Speed step	Auto + 8 speed
	Speed control	Power mosfet
Air filter	Type	Particle filter

Item		Specification
Heater	Type	Pin & Tube type
	Heating capacity	4,850 ± 5% kcal/hr
	Mode operating method	Actuator
	Temperature operating method	Actuator
Evaporator	Cooling capacity	4,500 ± 5% kcal/hr
	Temperature control type	Evaporator temperature sensor
	A/C ON/OFF	ON: 2.1 ± 0.5°C, (35.8 ± 32.9 °F) OFF: 0.6 ± 0.5°C, (33.1 ± 32.9 °F)

Tightening Torques

Items	N.m	kgf.m	lb-ft
Compressor	20 ~ 32.9	2.0 ~ 3.4	14.7 ~ 24.3
Condenser - Discharge hose	3.9 ~ 5.9	0.4 ~ 0.6	2.9 ~ 4.3
Condenser - Liquid tube
Compressor - Discharge hose	3.9 ~ 5.9	0.4 ~ 0.6	2.9 ~ 4.3
Compressor - Suction hose
Expansion valve - Evaporator	8.8 ~ 13.7	0.9 ~ 1.4	6.5 ~ 10.1

General Information

...

Troubleshooting

Troubleshooting Problem Symptoms Table Before replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor. ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: CVVT Oil Temperature Sensor (OTS) Description and Operation

Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by the engine speed and load. By controlling CVVT, the valve over-lap or under-lap occurs, which m ...

Hyundai Genesis (DH) 2013-2016 Service Manual: External AMP Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Open the trunk, remove the left trunk trim. (Refer to Body - "Trunk Trim") 3. Remove the external amplifier (C) after disconnecting the connector (A),(B) and loosening the mounting nuts. Installation 1. Install the externa ...