Hyundai Genesis (DH): General Information / Special Service Tools
| Special Service Tools |
| Tools (Number and name) | Illustration | Use |
| 09480-A3800 Inhibitor neutral fixed pin |
| Used to align the neutral position when installing the manual control lever on the inhibitor switch. |
Specifications ItemSpecificationsTransmission typeA8LR1Engine modelGasoline 3.8GDI (SBC)Torque converter type3-element, 1-stage, 2-phase typeOil pump systemInternal gear typeFriction elementsClutch: 4EABrake: 2EAOWC : 1EAPlanetary gear 3EAGear ratio1st3.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: PGS Unit (Back & Blinde Unit) Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing (A). (Refer to Body - "Glove Box") 3. Remove the PGS unit (A) after loosening the nuts. Installation 1. Install the PGS unit. 2. Install the glove box housing.
Hyundai Genesis (DH) 2013-2016 Service Manual: Mode Control Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4. Verify that the mode control actuator operates to the vent mode when connected in reverse.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Emission Control System
- General Information
- Body Electrical System
- New on site
- Most important about car
