Hyundai Genesis: Body Side Molding / Rear Wheel Guard Repair procedures

Replacement

• Put on gloves to prevent hand injuries.

• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • Take care not to scratch the body surface.

1.	Remove the rear tire.

2.	After loosening the mounting clips and screws, remove the rear wheel guard (A).

3.	Install in the reverse order of removal. • Replace any damaged clips.

Front Wheel Guard Repair procedures

Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around ...

A Pillar Garnish Repair procedures

Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Rear Glass Repair procedures

Removal     • In order to remove the rear glass, use the tools shown in the following figure: [Tooling Diagram] Square wire Insert-type wire grip [Tooling Assembly Diagram] • Insert and affix square wire into the insert hole of the wire grip . 1. Remov ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Repair procedures

Adjustment Glass Adjustment     • Check the glass run channels for damage or deterioration, and replace them if necessary. 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Remove the mounting hole plug (A) from the rear door module. ...