Hyundai Genesis: Rear Door / Rear Door Latch Repair procedures

Replacement

1.	Remove the rear door module. (Refer to Rear Door - "Rear Door Module")

2.	After loosening the mounting bolts, remove the rear door regulator (A).

3.	Disconnect the rear door latch connector (B).

4.	Remove the rear door latch assembly (C) by pulling it in the direction of the arrow.

5.	Remove the rear door inside handle cage (A).

6.	Remove the rear door inside handle cable (A) by pushing it rearward.

7.	Remove the rear door outside handle cable (A).

8.	Install in the reverse order of removal. • Make sure the connector is connected properly. • Make sure the door locks/unlocks and opens/closes properly. • Replace any damaged clips.

Rear Door Latch Components and Components Location

Component Location 1. Rear door latch ...

Body Side Molding

...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Accelerator Position Sensor (APS) Description and Operation

Description Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine control system, so it consists of the two sensors which adapt individual sensor power ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Components and Components Location

Components 1. Rear window glass ...