Hyundai Genesis: Rear Bumper / Rear Bumper Beam Assembly Repair procedures

Replacement

• Put on gloves to protect your hands.

• When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface. • Take care not to bend or scratch the trim and panels.

1.	Remove the rear bumper cover. (Refer to Rear Bumper - "Rear Bumper Cover")

2.	Remove the rear bumper wiring harness pin-type retainers (A).

3.	After loosening the mounting screws, remove the bracket (B).

4.	Remove fixing clips, then remove the rear bumper beam assembly (A).

5.	Install in the reverse order of removal. • Make sure the connector is connected properly. • Replace any damaged clips.

Rear Bumper Beam Assembly Components and Components Location

Component Location 1. Rear bumper beam assembly ...

Front Seat

...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Engine Coolant Temperature Sensor (ECTS) Specifications

Specification TemperatureResistance (k?)°C°F-40-4048.14-20-414.13 ~ 16.830325.7920682.31 ~ 2.59401041.15601400.59801760.32 ...

Hyundai Genesis (DH) 2013-2016 Owners Manual: Sliding the sunroof

When the sunshade is closed If you pull the sunroof control lever backward, the sunshade will slide all the way open then the sunroof glass will slide all the way open.To stop the sunroof movement at any point, pull or push the sunroof control lever momentarily. When the sunshade is ...