Hyundai Genesis: Airbag Module / Passenger Airbag (PAB) Module Repair procedures

Removal

1.	Disconnect the battery negative cable and wait for at least three minutes before beginning work.

2.	Remove the crash pad. (Refer to Body - "Crash Pad" )

3.	Disconnect the passenger airbag connector (A) and remove the mounting bolts (B). The airbag separate modules, the airbag cover side is placed so as to face upward.

Installation

1.	Disconnect the battery negative cable from battery and wait for at least three minutes before beginning work.

2.	Place a passenger airbag on the crash pad and tighten the passenger airbag mounting bolts(2) (A). Tightening torque : 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

3.	Install the crash pad. (Refer to Body - "Main Crash Pad Assembly")

4.	Tighten the passenger airbag mounting bolts (B) and Attach the connector to the airbag module (A). Tightening torque : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-.ft)

5.	install theGlove box housing (Reper Body - "Glove Box" )

6.	Reconnect the battery cable(-)

7.	After installing the passenger airbag, confirm proper system operation: Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off.

Passenger Airbag (PAB) Module Components and Components Location

Components ...

Side Airbag (SAB) Module Description and Operation

Description The Side Airbags (SAB) are installed inside the front seat and protects the driver and passenger from danger when a side crash occurs. The SRSCM determines deployment of the side ai ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Rear Bumper Cover Repair procedures

Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • When removing the interior trim pieces, use a ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Receiver-Drier Repair procedures

Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with the L wrench (A). Tightening torque : 9.81 ~ 14.71 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft) 3. Remove the receiver-drier (A) from condenser using a long nose plier. Check for crumbled ...