Hyundai Genesis (DH): Seat Electrical / Lumbar support switch Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Body Electrical System / Seat Electrical / Lumbar support switch Repair procedures

Removal
1.
Disconnect the battery(-) terminals.
2.
Remove the front seat shield outer cover.
(Refer to Body - "Front Seat Shield Outer Cover" )

3.
Loosen the screws and remove the electric seat control switch (A).

Installation
1.
Install the Electric seat control switch.
2.
Install the Front Seat Shield Outer cover.
3.
Connect the battery (-) terminals.
Inspection
Air Lumbar Support Switch
1.
Air lumbar support switch sends/receives signals via CAN communication so it is impossible to check the electric current of switch components.
2.
Inspect the air lumbar support system using GDS.
   
Check the air lumbar support system for normal operation by selecting

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Components and Components Location

    Component Location Index Engine Room [Lambda Engine] 1. Expansion Valve2. Suction & Liquid Tube Assembly3. Service Port (Low Pressure)4. Service Port (High Pressure)5. A/C Pressure Transducer (APT)6. Compressor7. Condenser8. Receiver-drier [Tau Engine] 1.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Refrigerant Line Repair procedures

    Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace any faulty tubes or hoses.     Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten the bolt or nut joint to the specified torque.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.025