Hyundai Genesis (DH): Seat Belt Pretensioner / Seat Belt Pretensioner (BPT) Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Restraint / Seat Belt Pretensioner / Seat Belt Pretensioner (BPT) Repair procedures

Removal
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front anchor seat belt (A).

   
? Anchor seat belt separation method
1) Expose the red colored indicator pin (A) by pushing the slot hole using a O 1.5mm pointed tool as below illustration.
   
Be careful not to scratch the anchor cover by a pointed tool when pusing the slot hole.
2) Put a (-) driver (O4mm) into a latch hole () and turn it clockwise.
3) Remove the connector by pulling seat belt ().
   
When connecting the anchor connector, securely connect it until "click" sound is heard.

3.
Remove the center pillar lower trim.
(Refer to Body - "Center Pillar Trim")
4.
Remove the center pillar upper trim.
(Refer to Body - "Center Pillar Trim")
5.
After loosening the mounting bolt, then remove the front seat belt lower anchor (A).
Tightening torque:
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

6.
Loosen the front seat belt webbing guide (A) mounting bolts.

7.
After disconnecting the pretensioner connector lock pin, remove the front seat belt pretensioner connectors (A), loosen the mounting bolts, then remove the front seat belt pretensioner (B).
Tightening torque (C) :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)
[Genral Type]

[PSB Option Type]

Installation
1.
Turn the ignition switch OFF.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Install in the reverse order of removal.
4.
Reconnect the battery negative cable.
5.
After installing the seat belt pretensioner, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off.

    Components

    Description The Emergency Fastening Device (EFD) operates at the same time with the Seat Belt Pretensioner when it satisifies the deployment condition after a collision.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Parking Assist Sensor Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front/rear bumper cover. (Refer to Body - "Front Bumper Cover") (Refer to Body - "Rear Bumper Cover") 3. Disconnect the connector (B) from the parking assist sensor (A).

    Hyundai Genesis (DH) 2013-2016 Service Manual: Compressor Repair procedures

    Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative (-) battery terminal. 3. Remove the engine room cover.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0329