Hyundai Genesis (DH): SRSCM / Front Impact Sensor (FIS) Description and Operation

Hyundai Genesis (DH) 2013-2016 Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS) Description and Operation

Description
The front impact sensor (FIS) is installed in the Front End Module (FEM). They are remote sensors that detect acceleration due to a collision at its mounting location. The primary purpose of the Front Impact Sensor (FIS) is to provide an indication of a collision. The Front Impact Sensor (FIS) sends acceleration data to the SRSCM.

    Removal 1. Turn the engine OFF. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 3. Remove the floor console assembly.

    Components

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: LKAS Unit Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the mirror wiring cover (A) and rain sensor cover (B). 3. Remove the LKAS unit connector (A). 4. Remove the LKAS unit after disengaging the mounting bracket (A). Installation 1.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Photo Sensor Repair procedures

    Inspection 1. Turn the ignition switch ON. 2. Connect the GDS. 3. Emit intensive light toward the photo sensor using a lamp, and check the output voltage change. 4. The voltage will rise with higher intensive light and fall with lower intensive light.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0234