Hyundai Genesis (DH): Tires/Wheels / Alignment Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Suspension System / Tires/Wheels / Alignment Repair procedures

Inspection
When using a wheel alignment tester to check the alignment of the wheels, make sure that the vehicle is horizontal and the front wheels are pointing straight ahead. Make sure that the suspension and steering equipment are normal, the wheels are straight.
Toe

Item
Description
A-B < 0
Positive (+) toe (toe in)
A-B > 0
Negative (-) toe (toe out)

   

    Wheel Runout 1. Jack up the vehicle and support it with jack stands. 2. Measure the wheel runout with a dial indicator as illustrated. 3. Replace the wheel if the wheel runout exceeds the limit.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Description and Operation

    Description BSD is a system that measures the speed of and distance from the following vehicles by using two magnetic wave radar sensors attached to the rear bumper, and detects any vehicle within the blind spot zone and gives off alarm (visual and auditory).

    Hyundai Genesis (DH) 2013-2016 Service Manual: Intake Actuator Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 and grounding terminal 4. Verify that the intake actuator operates to the recirculation position when connected in reverse.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0223