Hyundai Genesis (DH): Fuel Filler Door / Fuel Filler Door Release Actuator Repair procedures
| Inspection |
| 1. |
Remove the left luggage side trim.
(Refer to Body - "Luggage Side Trim") |
| 2. |
Remove the subwoofer or rear heater.
(Refer to AVN System - "Speakers") |
| 3. |
Remove the fuel filler housing after opening the fuel filler door.
(Refer to Body - "Fuel Filler Door") |
| 4. |
Loosen the two bolts of the fuel filler door release actuator.
|
| 5. |
Remove the fuel filler door release actuator (B) after disconnecting the fuel filler door release actuator connector (A).
|
| 6. |
Check for continuity between terminal No. 1 and No. 2. If
there is no continuity, replace the fuel filler door release actuator
(A).
|
Component Location 1. Fuel filler door open switch2. Fuel filler door release actuator
Inspection 1. Disconnect the battery(-) terminals. 2. Remove the crash pad Lower panel. 3. Disengage the retaining clips and remove the crash pad lower panel switch (A).
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Description and Operation
Description Integrated Rain Sensor Integrated rain sensor (A) controls three systems: front wiper, auto-light, and central air conditioner. 1. Wiper Control System When "AUTO" switch signal is received from the multi-function switch on the right, the integrated rain sensor detects the amount of rainfall.
Hyundai Genesis (DH) 2013-2016 Service Manual: Compressor Description and Operation
Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low-pressure and low-temperature refrigerant gas into high-pressure and high-temperature refrigerant gas.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Description and Operation
- Transmission Control Module (TCM) Repair procedures
- Body Electrical System
- New on site
- Most important about car
