Hyundai Genesis: Interior Trim / Front Pillar Trim Repair procedures

Replacement

• Put on gloves to prevent hand injuries.

• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface. • Take care not to bend or scratch the trim and panels.

1.

Remove the front pillar trim. (1) To remove the front pillar trim, the fastener remover (A) below must be used. (2) After slightly lifting up the front pillar trim and putting the tool in, remove the mounting clip (A) by pulling it • Once the front pillar trim is removed, be sure to replace the clips with new ones (3) Remove the front pillar trim (A). • Front Pillar Trim Mounting Method • Once the front pillar trim is removed, be sure to replace the clips with new ones.

2.	Install in the reverse order of removal. • Replace any damaged clips.

Front Pillar Trim Components and Components Location

Component Location 1. Front pillar trim ...

Center Pillar Trim Components and Components Location

Component Location 1. Center pillar lower trim2.Center pillar upper trim ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Repair procedures

Adjustment TCM Learning When shift shock occurs or parts related with the transmission are replaced, TCM learning should be performed. In the following case, TCM learning is required. • Transmission assembly replacement • TCM replacement • TCM upgrading 1. TCM ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Rear Lower Arm Repair procedures

Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from the rear hub. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)     Be careful not to damage the ...