Hyundai Genesis (DH): Front Door / Front Door Window Glass Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Body (Interior and Exterior) / Front Door / Front Door Window Glass Repair procedures

Replacement
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
After loosening the mounting screws, remove the front door belt outside weatherstrip (A).

3.
Separating the mounting plug hole (A) from the front door module.
Lower the glass by operating the power window switch until the glass mounting bolt is exposed in the plug hole
4.
After unscrewing the mounting bolt (B) as loosely as possible and completely loosening the bolt (C), tilt the front door window glass (D) to pull out it upwards.
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

   

    Component Location 1. Front door window glass

    Component Location 1. Front door module

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Repair procedures

    Diagnosis With GDS 1. BSD system defects can be quickly diagnosed with the GDS. GDS operates actuator quickly to monitor, input/output value and self diagnosis. 2. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, and turn on the GDS.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Compressor oil Repair procedures

    Oil Specification 1. The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. 2. Compressor (PAG) oil varies according to compressor model. Be sure to use oil specified for the compressor model.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0284