Hyundai Genesis: Mirror / Outside Rear View Mirror Repair procedures

Replacement

• Put on gloves to prevent hand injuries.

• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components • Take care not to scratch the body surface.

1.	After loosening the mounting clips, remove the front door frame inner cover (A).

2.	Disconnect the outside rear view mirror connector (A).

3.	After loosening the mounting bolts, remove the outside rear view mirror (B). Tightening torque : 6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

4.	Install in the reverse order of removal. • Make sure the connector is connected properly. • Replace any damaged clips.

Outside Rear View Mirror Components and Components Location

Component Location 1. Outside rear view mirror ...

Inside Rear View Mirror Components and Components Location

Component Location 1. Inside rear view mirror ...

Other information:

Hyundai Genesis (DH) 2013-2016 Owners Manual: Warning messages

To disengage EPB, fasten seatbelt, close door, hood, and trunk If you try to drive with the EPB applied, a warning will sound and a message will appear. If the driver's seat belt is not fastened and the hood or trunk is opened, a warning will sound and a message will appear. ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Engine Coolant Temperature Sensor (ECTS) Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the ECTS connector. 3. Remove the ECTS (Refer to "Removal"). 4. After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals 3 and 4. 5. Check that the resistance is withi ...