Hyundai Genesis (DH): Front Seat Belt / Front Seat Belt Buckle Repair procedures

Replacement
1.
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly")
2.
Remove the two fixing clips using a flat-tip screwdriver, and then remove the front seat integration connector cover (B).

3.
To remove the front seat belt buckle connector, use a sharp-pointed tool (A) like the picture below.

4.
To remove the front seat belt buckle connector, put the sharp-pointed tools into the two holes in the front seat belt buckle connector.

5.
Pull up the front seat belt buckle connector (A).

6.
Disconnect the connectors (A).
7.
After loosening the mounting screws, remove the memory power seat unit (B).

8.
After loosening the mounting screws, remove the front seat under cover (A).

9.
Disconnect the memory power seat unit connectors (A).

10.
Remove the front seat belt buckle connector wiring harness (A).

11.
After loosening the mounting bolt, remove the front seat belt buckle (A).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5kgf.m, 28.9 ~ 39.8 lb-ft)

12.
Install in the reverse order of removal.
   

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Condenser Repair procedures

    Inspection 1. Check the condenser fins for clogging and damage. If they are clogged, clean them with water, and blow them with compressed air. If they are bent, gently bend them using a screwdriver or pliers. 2. Check the condenser connections for leakage, and repair or replace it, if required.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Mode Control Actuator Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4. Verify that the mode control actuator operates to the vent mode when connected in reverse.

    Categories

     
    Copyright В© 2025 www.hgenesisdh.com - 0.0266